Customer Parameter programming required: 1) Idle Shutdown Time programmed in the 1 – 1440 minutes range. 5) Transmission Neutral Switch (If Transmission style parameter is programmed to Automatic Option 3, Automatic option 4, AT/MT/HT Option 3, or AT/MT/HT Option 4). 4) Clutch Pedal Position Switch.(If Transmission Style is programmed to Manual Option 1 or 2, Universal). 3) Service Brake Pedal Position Switch #1.(Service Brake Switch #2 if required by transmission style). OEM provided and installed components required: 1) Vehicle speed source. Note:If the transmission neutral switch is programmed and installed, the idle shutdown timer will not start counting if the transmission indicates that the transmission is in gear. The status of the Shutdown Timer will be broadcast as part of the J1939 Data Link SHUTDOWN message $FEE4 (65,252). The operator can move the clutch or service brake during Driver Alert to override the timer.When the timer is overridden a diagnostic event is logged.The timer will remain in Override until the ECM has detected that the vehicle has moved. In the above command, 300 seconds (5 minutes) represents the number of seconds for the timer. In the shortcut wizard, type the following command in the Type the location of the item field: Shutdown -s -t 300. If the Idle Shutdown Timer is programmed to two minutes or more, the check engine lamp will begin to flash ninety seconds before the programmed time expires. To create a shut down timer desktop shortcut: Right-click on your Windows desktop and select New > Shortcut. When the Idle Shutdown Timer is programmed to one minute, the check engine lamp will begin to flash thirty seconds before the programmed time expires. The Engine-Idle Shutdown Module is installed in the same location as the Reverse Aid Module and the Reverse Aid system is standard on Lariat or better trim. The Idle Shutdown Timer can be programmed between 1 and 1,440 minutes.The check engine lamp will begin to flash when the Idle Shutdown Timer enters the Driver Alert phase of the Idle Shutdown sequence.The Driver Alert phase is determined by the number of minutes programmed for the Idle Shutdown Timer, during this phase the check engine lamp will flash, warning the driver of an impending engine shutdown. To conserve fuel, the control system can be programmed to shut down the engine.The engine will shut down if it operates under reduced load with the vehicle stationary for a customer-defined period of time.This feature does not shut off vehicle electrical power.
0 Comments
Leave a Reply. |